Monday, May 18, 2015

Sounds good

Fired her up for the first time ina while, sounds good after sitting over 6 months


67 Finally rolls out

For the first time in over a year, the 67 finally saw some sunlight on all 4 tires, milestone achieved.

Rear End back in

rear end back in, just needs the shocks and drive shaft installed


Fitting new frame rail

After everything has been cleaned up its time to fit the new frame rail and fill in some holes that were left over from the old rail removal.


Drivers side frame rail

Now that the quarter is welded in and everything is even as it should be the frame rail can be removed with a few braces added to avoid sagging and later spring back


Driver side quarter finally welde in


Drivers side inner fenderwell

Fitted, prepped and welded the inner and outer wheel wells to the body, coated in primer and ready to go


Driver side door jamb repair

Fitted and welded the drivers side door jamb repair panel, now it looks as it should


Tuesday, December 16, 2014

67 Left quarter fitment

Removed the tail light panel and realized that there is yet even more Bondo and chicken wire holding this car together, still more fitting and trying to figure out how to make the car square again.


The 69 reasebly begins....again....

Everything had to be put back together, the engine was removed, the the exhaust cut, all wiring pulled out, and fairly much everything was back to square one.... spent all weekend trying to get it all back togather